24V LED Kit for 3D Printers - Mount to any extrusions - Ready for 24v, or 12v -

This kit will be our new custom made (in Fusion 360) 24V LED Light Bar kit that will be made first for the 300mm RatRig V-Core 3, and also the Voron 2.4 350mm and then adapter to other printers as the measurements are sent to us. It's basically just a extrusion mountable rail, that will accept a 24V led strip. We will pre-fab with soldered leads and possibly an optional lens, or offer it as a kit in pieces. This will upgrade your system to avoid mounting these LED strips directly to extrusion with the included double-sided tape they come with. We use an "upgraded" 2 part epoxy, and though you won't have the cooling you would have from mounting directly to extrusion we don't suspect high heat at the voltages or amperage we are running these at; but consider this a beta phase and keep close attention. We may need to upgrade the kit to include an extra aluminum heatsink for the LED strips if heat becomes an issue with enclosed printers (currently being tested) AND SHOULD BE RUN AT YOUR OWN RISK! We will be testing the current draw over the next few days, with an inline circuit to monitor between low usage and high usage. We are wiring these onto the spare extruder MOSFETs, so there is plenty of power on our boards, but some custom options may not have the spare power and need to wire directly into a 24V power supply, and switch the low side with an external switch/mosfet. Contact me with concerns. Current LED Rail Options: 24V Voron 350mm = 18" Rail 24V RatRig 300mm