Diane Von Furstenberg Bentley Dress
$58
Pay in 4 interest-free payments of $14.50
with .
Learn More
.
Size
Like and save for later
Add To Bundle
Navy Bentley Short Three Quarters. In good used condition. A bit winkled but can steam it before shipping
Shipping/Discount





wearesure
and
23 others
like this
29 Comments

dejashopgirl
what are the measurements? And if you were to call the number size what would you call it?
May 31Reply

l_ski
@dejashopgirl Hello. I’m not quite sure. I added the DVF size chart to the listing. Hopefully that helps
May 31Reply

dejashopgirl
@l_ski I appreciate that. I know sometimes these charts don't always reflect the specific item but are more of a general. so I was hoping maybe you could do the measurements. I like to always inquire since I can't try it on and I always like to offer it when I'm selling. thank you
May 31Reply

l_ski
@dejashopgirl I can do measurements for you. Work long 12-14 hours today and tomorrow. So thinking late tomorrow night if that’s ok
May 31Reply

dejashopgirl
@l_ski no hurry, thank you. I appreciate it! 🙏
May 31Reply

l_ski
@dejashopgirl Approximately 19’ pit to pit. Not sure about the waist since I don’t know where it sits. I’m going to put it on my mannequin to see if I can find an approximate measuring point. It is stretchy though.
Jun 02Reply

l_ski
@dejashopgirl Yeah…putting it on the mannequin didn’t work as it’s too big and won’t hold onto the open shoulders without sliding down
Jun 02Reply

l_ski
@dejashopgirl Best guess as where to measure the waist at is approximately 16” laying flat. Again, the dress is stretchy. Both that and the pit to pit measurement that I took seem to be consistent with the DVF size chart
Jun 02Reply

dejashopgirl
@l_ski thank you for looking more into it. I am a little bit confused however, as it sounds like you're seeing it's 19 in pit to pit, which would be 38 in around. It looks like that fits into the DVF chart of a size medium chest running up to 38.2 on a size medium. do you think perhaps your dress is more of a medium?
Jun 03Reply

l_ski
@dejashopgirl I tried it on for you. I can sometimes wear a medium. This is very loose on me. And as it is supposed to be bodycon, I think it’s more of a large.
Jun 03Reply

dejashopgirl
@l_ski it's a shame I can't try it on. I'm definitely a size 10 so 99% of the time I wear a medium, so I'm guessing this is probably not going to be a good fit. bummer
Jun 03Reply

l_ski
@dejashopgirl I am a size 4. Sometimes I can wear a 6.
Jun 03Reply

dejashopgirl
@l_ski hmmm, well sounds like It runs a little small then, More like a medium if it fits you but it's loose. could you tell me the measurements of the hips and then the length? thank you
Jun 03Reply

l_ski
@dejashopgirl Yes. I should be able to later tonight
Jun 03Reply

l_ski
@dejashopgirl From pit to hem it’s approximately 28”. Since this sits off the shoulders that’s the best measurement for the length.
Jun 04Reply

l_ski
@dejashopgirl Not sure exactly where to measure for the hips as that is going to depend on an individual’s torso length. Measured where I thought they would be at approximately 19” laying flat.
Jun 04Reply

l_ski
This measurement was taken 14” down from the pit
Jun 04Reply

l_ski
Took the waist measurement at the narrowest part of the dress at approximately 14” laying flat
Jun 04Reply

l_ski
It is very hard to measure this dress as it is ruched and stretchy. I am trying to take the measurements unstretched as best as I can
Jun 04Reply

dejashopgirl
@l_ski thank you. if you could just include from collarbone to hem for length that would be great. thanks
Jun 04Reply

dejashopgirl
shoulder to hem
Jun 04Reply

l_ski
@dejashopgirl Since this dress is too big for me there is no fabric sitting at the collarbone for me. It’s a deep V-neck on me
Jun 04Reply

l_ski
@dejashopgirl This is tough as well. There is no shoulder seam at the top. So just laying it flat from the highest point of the seam for the sleeve to the hem is approximately 36”
Jun 04Reply

l_ski
Maybe 37”
Jun 04Reply

dejashopgirl
@l_ski yeah I usually just put a dress on a hanger and measure from the top to the bottom, then it's a universal measurement. I appreciate all the measurements. thank you
Jun 04Reply

l_ski
@dejashopgirl Because it does not sit on the shoulder, it won’t hang on a hangar
Jun 04Reply

dejashopgirl
@l_ski oh, gotcha. I would not had guessed that. well maybe just laying it out on a flat surface and measuring it.
Jun 04Reply

l_ski
@dejashopgirl that’s what I did to give you the measurements
Jun 04Reply

dejashopgirl
@l_ski gotcha, thank you again for the information I will have to figure that out.
Jun 04Reply
Trending Now
Find Similar Listings